10 Meetups Around Nissan Qashqai Key Fob You Should Attend
replace nissan key Why Your Nissan Qashqai Key Fob Won't Work
The Qashqai's large dimensions give it an SUV-like feel. Its ride on 19-inch alloy wheels in Ti and STL versions may also be a bit firm. The front tyres may lose grip on rough surfaces and its CVT might occasionally exhibit wrist-flexing torque steer.
This is typically caused by the battery of a coin that is dead. It is easily repaired in a matter of minutes. Make sure the replacement battery is of the same voltage, size and specifications.
Water Damage
One of the main reasons a Nissan key fob will give the "key ID is not correct" message is due to water damage. The key fob is fitted with rubber seals that protect the electronic chip inside, however prolonged exposure to moisture can cause it to cease functioning properly. It's typical to observe this if your key fob has been dropped in the water or a swimming pool. However, it could also happen when it gets wet from the rain or soapy hands.
If your key fob has been exposed to water over an extended period of time and you're not sure, clean it with isopropyl, or an electronic cleaner. It could also require to be taken to a professional to be repaired or replaced.
If your key fob needs to be replaced, it's quite simple to do. Make sure you have the right multipack (CR2032 3V). Then, you can open the front and back cases with the help of a small screwdriver. You'll need to take out the clips for retaining metal and pull out the battery that was in place, and then replace it with the new one. Reassemble the fob and replace the mechanical key. Verify that it is working correctly. If it isn't then you'll need to take it to a local Nissan dealer or an experienced auto locksmith to repair the chip that controls the key. The chip is usually not damaged by water and therefore shouldn't be too expensive.
Dead Coin Battery
Another common reason your Nissan Qashqai key fob may not work is because the battery for the coin is dead. These batteries last for 3-5 years, but they are prone to failure over time if the fob has been frequentedly dropped. It is possible to replace the battery with a new one but be sure it's the same voltage and size as the original. If you use a new battery, it may cause the key to be assigned a wrong key ID. This can prevent it from being connected to your vehicle.
The best method to replace the coin battery on the Nissan Qashqai key fob is by removing the key fob using a small flat head screwdriver. The screwdriver should be inserted into a small notch at the bottom of your key fob. The screwdriver should be gently twisted to break the two halves. Then, take out the old CR2025 button cell battery and insert a new one after noting its location on the fob.
Examine the terminals for dirt or water damage prior to installing the new battery. If so, clean the terminals using the smallest amount of isopropylethanol. You'll also want to make sure the pole cables are plugged in correctly - they should be connected to the negative and positive poles of the battery respectively.
Troubleshooting
If your Nissan Qashqai's key fob stops working after being exposed to clean tap or rain water it could be a sign there is a problem with the internal chip. Changing the battery won't fix this issue, and you'll have to buy a new key fob. If the key fob has stopped working after you dropped it, it is likely that the chip inside was damaged. If you clean the chip using isopropylethanol and paper towels and then replace it with the key fob, it is possible to usually get it working again.
Key ID Incorrect is a common error you may see on the dashboard of your car. This means that the vehicle is unable to recognize the key fob and not allow it to start the engine. This problem could be caused in numerous ways, including water damage, malfunctions that are not detectable in the key fob circuitry or RFID interference.
The key fob will not function if the 12 volt batteries are not working or provide enough electric current. This could affect the remote keyless system as well as central locking in your Nissan Qashqai, as well as hindering you from starting your engine with the key fob (if equipped with Intelligent Key). Check the batteries inside the key fob if you're unable to lock or unlock your door by hand. Try reconnecting the battery in order to reset your transmitter.
Reprogramming
If the key fob was not submerged in saltwater the device should be able to be restored to its original state by a simple wash of clean water. You can also clean the electronic component using isopropyl or electronic cleaner. If none of these methods work it is possible to replace the key fob.
If your Nissan Intelligent Key still does not work, there could be a connection issue between it and your vehicle. To relink it, start by turning the key in the ignition, but not starting the car. Repeat this process until the hazard light flashes twice. Turn the vehicle off and remove the keys.
Open the fob compartment in your vehicle's fob compartment. It is usually located on a door jamb or the handle of the door for the driver. Find the small "program" button and press it. You will hear a chime once the process is complete.
It's time to test your Intelligent Key to the test. Set your feet a distance from the vehicle, then press all the buttons on the key. If the lights flash and the horn sounds it means the key is successfully linked to the Nissan. You can also test it near the Nissan.